Rs-ba1 version 2 ip remote control softwa

#RS BA1 VERSION 2 IP REMOTE CONTROL SOFTWA HOW TO#
#RS BA1 VERSION 2 IP REMOTE CONTROL SOFTWA MANUAL#
#RS BA1 VERSION 2 IP REMOTE CONTROL SOFTWA SOFTWARE#

q Enter a name for the radio in the Radio NameДЇield. W The Radio List screen appears, then click. Q Select the Server Setting mode from a drop-down list located at the top of the screen, and then click the tab. R After clicking, Take effect after restarting the ap-plication appears, then click, and restart the Remote Utility. FTTH) e Click to save the network settings. icom) w Select your internet access line type in the In. q Enter a name for your PC in the PC NameДЇield. Top to open the Remote Utility.w Please set your own PC information appears, Please configure the system using your own settings.ДЎ Network settingq Double-click the Remote Utility icon on your desk. NOTE:The domain name, password, and other settings in this illustration are only an example. USB cable(Supplied to the RS-BA1 or a radio) Model : IC-9100abcCI-V address : 7CBaud rate : 19200Дomain name : User ID : user 1Password : Icom12345 * In this illustration, routers or other devices are not described. Step 2: Installation guide q Step 1: Preparations Step 3: Installation guide w

#RS BA1 VERSION 2 IP REMOTE CONTROL SOFTWA HOW TO#

This section describes how to setup the Base station (Serv-er) PC.Before configuring the settings, connect a radio to the PC following the RS-BA1 Installation guide q, and then turn on the radio.

#RS BA1 VERSION 2 IP REMOTE CONTROL SOFTWA MANUAL#

See the RS-BA1 Instruction Manual included in the CD, for details. When your PC is used as a Remote station, adjust the audio level of the device that your microphone, speaker, or headset isД¬onnected to. When your PC is used as a Base station, adjust the audio level of the device that is connected to your radio. See your routers manual for details of how to configure the settings.Д«efore you start communicating using the RS-BA1, the PCs audio volume must be set to a proper level. If you configure the remote control system through the Internet, you need to configure your Base station and Remote station routers to allow access from the Internet.Д¬onfigure the port forwarding settings, and IP filter settings on your router, for port numbers 50001, 50002, and 50003. To let the Remote Utility work properly, it must be added as an exception in the Firewall. To configure the remote control system, the following settings are required.

#RS BA1 VERSION 2 IP REMOTE CONTROL SOFTWA SOFTWARE#

While the software is open, push the key of the PCs keyboard to open the help file. You can also refer to each softwares help file, for assistance with the functions and settings. See the Instruction Manual included in the CD, for detailed instructions on the RS-BA1. BE CAREFUL in managing IDs and passwords.

You need to register the ID and password to the Base station to enable the Remote station to access the Base station and the radio. We recommend that you place the Remote stations PC near to the Base station's PC and a radio, to check that the settings are correct, and that you can correctly control the radio. In this example, a radio is connected to the Base stations PC with the supplied USB cable, and a remote station remotely controls the radio through the Internet. This guide explains the minimum required settings to configure a remote control system, taking the following illustration as an example. This guide contains instructions on how to config-ure the remote control system, and how to remotely control a radio.Before reading this guide, please finish the installa-tion and connection, following the RS-BA1 Prepara-tions and Installation guide q.See the RS-BA1 Instruction Manual included in the CD, for detailed instructions.

Rs-ba1 version 2 ip remote control softwa